Fault Codes - KickAss KADCDC25A-AND User Manual

Recovery Mode Indicator:
When the lithium battery has entered recovery mode, the KickAss DCDC MPPT Solar Battery
Charger display will have the source indicator illuminated (eg; SOLAR) and the battery type
LITHIUM will be flashing. See diagram below.
Source will
Illuminate solid
When the battery voltage has been recovered to 12V, the DCDC charger will automatically
change to normal stage charging programs and loads may be reconnected.

FAULT CODES

If all battery type selection lights are flashing simultaneously please see troubleshooting guide below.
MODE
GEL
There are error codes that may be displayed. These will be displayed in the
following way:
S1
Stage LED
LED
Solar input
high voltage
Solar input
reverse
Alternator
high voltage
Alternator
input reverse
Output
fault mode
NOTE: To activate the Charger when the auxiliary battery is below 9V, for a short period of time. You can then
remove the jumper cables.
MODE
SOLAR
ALTERNATOR
CHARGING
BATTERY TYPE
AGM WET CALCIUM
S2 S3 S4
LED LED LED
Over voltage is detected
Solar input is reversely
Overvoltage is detected
Overvoltage is detected
BATTERY TYPE
GEL AGM
1 2 3
BULK ABSORPTION FLOAT
LITHIUM
Cause
at solar input
connected
at alternator input
Alternator input is
reversely connected
Output battery is
reversely connected
at output
Output open circuit
or dead battery
13
WET CALCIUM LITHIUM
12V 25A DC 4-STAGE
4
PULSE
Remedy
Check solar panel
open circuit voltage
Check solar input
connection
Check vehicle
battery voltage
Check alternator
input connection
Check output
cable connection
Check auxiliary
battery voltage
Check auxiliary battery
voltage & cable connections