3
Click Settings then Fingerprint Storage Inspector.
The Fingerprint Storage Inspector screen is displayed.
4
If other fingerprint data is still displayed on the list, hold down
the
selected, then click Remove.
5
Click OK to make the changes permanent.
6
Check that all Fingerprint data was deleted on the Fingerprint
Storage Inspector screen.
Care and maintenance of your fingerprint reader
Failure to follow these guidelines and/or procedures might result in
damage to the reader or cause reader failure, finger recognition
problems, or lower finger recognition success rate.
❖
Do not scratch or poke the reader with your nails or any hard or
sharp objects.
❖
Do not press the reader with too much pressure.
❖
Do not touch the reader with a wet finger or any wet objects.
Keep reader surface dry and free of water vapor.
❖
Do not touch the reader with a soiled finger. Minute foreign
particles on a soiled or dirty finger may scratch the reader.
❖
Do not paste stickers or write on the reader.
❖
Do not touch the reader with a finger or any object with built-
up static electricity.
Observe the following before you swipe your finger on the reader,
whether for fingerprint enrollment/registration or recognition.
❖
Wash and dry your hands thoroughly.
❖
Remove static electricity from your fingers by touching any
metal surface. Static electricity is a common cause of reader
failures, especially during dry seasons such as winter.
❖
Clean the reader with a lint-free cloth. Do not use detergent to
clean the reader.
Fingerprint Authentication Utility
key and select each fingerprint until they are all
Control
Toshiba Utilities
163