Retrospec Ripper 200 Owner's Manual page 4

COLLAR CLAMP
Using a 5mm hex wrench, check that the Collar Clamp Bolt is tightened securely. This
bolt is tightened at the factory, but should be checked before riding (Fig. 9).
CARE
Clean, wipe with a damp cloth. Do not use industrial cleaners, solvents, alcohol or
ammonia-based cleaners – they may damage surfaces and plastic parts. Get in the
habit of inspecting your scooter on a regular basis and before every ride.
The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from the date of purchase. This Limited Warranty does not cover normal wear and tear, or
any damage, failure or loss caused by improper assembly, maintenance, or storage.
This Limited Warranty will be void if the product is ever used in a manner other than for recreation, modified in any way, or used as a rental.
Retrospec does not o er an extended warranty. If you have purchased an extended warranty, it must be honored by the store at which it was purchased.
The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product. For your records, save your original sales receipt with this
manual.
RIDE AT YOR OWN RISK AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION. USE CAUTION AND COMMON SENSE.
TIGHTEN
(CLOCKWISE)
Fig. 9
RETROSPEC LIMITED WARRANTY
RETROSPEC.COM
RIDING:
Place one foot on the deck and push with the other foot. Steer with both hands on the
handgrips. Turn handlebar left or right, for enhanced cornering, lean slightly into the
direction of the turn.
BRAKING/STOPPING:
Step onto the foot brake over the rear wheel to slow or stop. It is recommended you
practice applying the brake at various speeds and in an open area free from
obstructions (Fig. 10).
(213) 744-1555
FOOT
BRAKE
Fig. 10
TEAM@RETROSPEC.COM