Haier HW90-B14636 User Manual page 26

10-Installation
10-5
10.5 Drain Water Connection
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! If possible keep always drain
hose fixed to the clip at the appliance back.
WARNING!
▶ Use only the supplied hose set for the connection.
▶ Never reuse old hose sets!
▶ Only connect to cold water supply.
▶ Before connection, check whether the water is clean and clear.
10-6 10-7
26
10.4 Aligning the appliance
Adjust all feet (Fig. 10-5) to achieve a complete level
position. This will minimize vibrations and thus noise
during use. It will also reduce wear and tear. We recom-
mend to use a spirit level for adjustment. Floor should
be as stable and flat as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten locknut (1) against the housing.
Following connections are possible:
10.5.1 Drain hose to sink
▶
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-6).
▶
Protect the U-support sufficiently against slip-
ping.
10.5.2 Drain hose to waste water connection
▶
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶
Put the drain hose for approx. 80 mm in the
wastewater pipe.
▶
Attach the U-support and secure it sufficiently
(Fig. 10-7).
GB