Haier HW90-B14636 User Manual page 23

GB
Program Cause
• Water level sensor-error
FA
• Temperature sensor - error..
F3
• Heating error
F4
• Motor - error..
F7
• Abnormal communication error
FC0、 FC1
or FC2
• Unbalanced load - error..
UnB
9.3 Troubleshooting without display code
Problem
Washing machine fails
to operate.
Washing machine
water.
Machine is draining • Height of drain hose is below 80 cm.
Drainage failure.
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
Cause
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is activated.
• No water.
• Inlet hose is kinked.
•
• Water pressure is less than 0.03 MPa.
• Door is not properly closed.
• Water supply failure.
• Drain hose end could reach into
water.
• Drain hose is blocked.
•
• Drain hose end is higher than 100 cm
above floor level.
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
9-Troubleshooting
Solution
• Contact the After sales service..
• Contact the After sales service..
• Contact the After sales service..
• Contact the After sales service..
• Contact the After sales service..
• C e h k c a d n b
Reduce the load.
Solution
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
•
• Check water pressure.
• Close the door properly.
• Ensure the water supply.
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• Unblock drain hose.
•
• Make sure that drain hose is
properly installed.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
l a n a e c a l n u r d l y a o i d t n e h d u r . m
23