Locating The Fuses; Drive System Maintenance; Checking The Tire Pressure; Checking The Torque Of The Wheel Nuts - Toro Greensmaster TriFlex 3300 Operator's Manual

WARNING
Incorrect battery cable routing could damage
the tractor and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
If corrosion occurs at the terminals, disconnect the
cables, negative (-) cable first, and scrape the clamps
and terminals separately. Connect the cables, positive
(+) cable first, and coat the terminals with petroleum
jelly.

Locating the Fuses

The fuses in the electrical system are located under
the seat (Figure 34).
Figure 34
1. Start/run, Diagnostic
lights, and leak
detector—7.5 A
2. Reel engage and
lift/lower—7.5 A
3. Lift reel and E-reel
enable—7.5 A
4. Hydraulic fan kit
(optional)—15 A
g195277
5. No fuse
6. Lights and leak
detector—15 A
7. Run—10 A
8. ECM logic and power—2
A
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Before each use or daily
Vary the tire pressure for all 3 wheels, depending
upon your turf conditions, from a minimum of 83 to a
maximum of 110 kPa (12 psi to 16 psi).
Checking the Torque of the
Wheel Nuts
Service Interval: After the first hour
After the first 10 hours
Every 200 hours
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Torque the wheel nuts to the specified torque
at the specified intervals.
Wheel nut torque specification: 95 to 122 N∙m (70
to 90 ft-lb)
Note:
To ensure even distribution, torque the wheel
nuts in a X pattern.
Adjusting the Transmission
for Neutral
If the machine creeps when the traction-control pedal
is in the N position, adjust the neutral-return
EUTRAL
mechanism.
1. Ensure that the bypass valve is closed.
2. Lift the machine and support it at the frame so
that 1 of the front wheels is off the floor.
Note:
If the machine is equipped with a 3-Wheel
Drive Kit, also raise and block the rear wheel.
3. Start the engine, move the throttle to the S
position, and ensure that the front wheel that is
off the floor is not rotating.
4. If the wheel is rotating, shut off the engine and
proceed as follows:
A. Loosen the nut securing the eccentric to the
top of the hydrostat
33
LOW
(Figure 35).