Adjusting The Mowing Speed; Brake Maintenance; Burnishing The Brakes; Adjusting The Brakes - Toro Greensmaster TriFlex 3300 Operator's Manual

Adjusting the Mowing
Speed
The mow speed is set to 3.8 mph at the factory.
You can adjust the forward moving speed from 0 to 8
km/h (0 to 5 mph).
1. Loosen the jam nut on the trunnion bolt
37).
2. Loosen the nut securing the lock and mow
brackets on the pedal pivot.
Figure 37
1. Jam nut
2. Nut
3. Rotate the trunnion bolt clockwise to reduce the
mowing speed and counterclockwise to increase
the mowing speed.
4. Tighten the jam nut on the trunnion bolt and the
nut on the pedal pivot to lock the adjustment
(Figure 37). Check the adjustment and adjust
as required.
(Figure
g014625
3. Trunnion bolt

Brake Maintenance

Burnishing the Brakes

Service Interval: Yearly
Firmly apply the brakes and drive the machine at
mowing speed until the brakes are hot, as indicated
by their smell. You may need to adjust the brakes
after the break-in period; refer to
(page 35).

Adjusting the Brakes

If the brake fails to hold the machine while parked,
you can adjust the brakes using the bulkhead fitting
near the brake drum; contact your Authorized Service
Dealer or refer to the Service Manual for more
information.
Note:
Burnish the brakes annually; refer to
Burnishing the Brakes (page
35
Adjusting the Brakes
35).