Hauling The Machine; Towing The Machine - Toro Greensmaster TriFlex 3300 Operator's Manual

pressure does not contaminate and damage the seals
and bearings. Do not wash a warm engine or the
electrical connections with water.
After cleaning the machine, do the following:
•
Inspect the machine for possible hydraulic
fluid leaks, damage or wear to hydraulic and
mechanical components.
•
Inspect the cutting units for sharpness.
•
Lubricate the brake-shaft assembly with SAE 30
oil or spray lubricant to deter corrosion and help
keep the machine performing satisfactorily during
the next mowing operation.

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use a full-width ramp for loading the machine into
a trailer or a truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine (Figure 26).
Figure 26
1. Tie-down loop (each side)
g276052
2. Rear tie-down loop

Towing the Machine

In case of an emergency, you can tow the machine
for up to 0.4 km (1/4 mile).
Important:
Do not tow the machine faster than 3
to 5 km/h (2 to 3 mph) to avoid damaging the drive
system. If you must move the machine more than
0.4 km (1/4 mile), transport it on a truck or trailer.
1. Locate the bypass valve on the pump and rotate
it so that the slot is vertical
1. Bypass valve-slot shown in closed (horizontal) position
2. Before starting the engine, close the bypass
valve by rotating it so that the slot is horizontal
(Figure 27).
Important:
Do not start the engine when the
bypass valve is open.
26
(Figure 27).
Figure 27
g014627