Table of Contents
Advertisement
Installation and Maintenance
BACnet
IP Communication Module for
®
MicroTech
®
Applied Rooftop Systems and Self-Contained Units
Models: DPS, DPH, MPS, RAH, RCE, RCS, RDE, RDS, RDT, RFS, RPE,
RPS, SWP and SWT
III and MicroTech
IM 916-5
Group: Controls
Part Number: IM 916
Date: August 2020
4 Unit Controllers
®
Advertisement
Table of Contents
Related Manuals for Daikin BACnet MT3041
Summary of Contents for Daikin BACnet MT3041
- Page 1 Installation and Maintenance IM 916-5 Group: Controls Part Number: IM 916 Date: August 2020 BACnet IP Communication Module for ® MicroTech III and MicroTech 4 Unit Controllers ® ® Applied Rooftop Systems and Self-Contained Units Models: DPS, DPH, MPS, RAH, RCE, RCS, RDE, RDS, RDT, RFS, RPE, RPS, SWP and SWT...
-
Page 2: Table Of Contents
Table of Contents Table of Contents General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Integration . -
Page 3: General Information
IM 916-4 Dec 2019 Rebranded layout and added MicroTech 4 Rebel Applied. Other minor corrections. to correct the interference at his or her own expense. Daikin disclaims any IM 916-5 Aug 2020 OM 1288 added to Reference Documents liability resulting from any interference or for the correction thereof. -
Page 4: Product Information
Product Information Inc; Windows from Microsoft Corporation; Daikin, Maverick II, Rebel, and MicroTech from Daikin Applied Americas. Product Information This manual provides instructions for installing or replacing Component Data the BACnet communication module on a MicroTech 4 (Rebel Applied) or MicroTech III (Rooftop Applied Systems, Self-... -
Page 5: Light Emitting Diodes (Leds)
Product Information Light Emitting Diodes (LEDs) Board-to-Board Connector The BACnet communication module has a BSP LED and a The board-to-board connector connects the unit controller to BUS LED to indicate communication activity and status of the the BACnet communication module (Figure 3 Figure BACnet communication module. -
Page 6: Installation
Installation Installation 7. Insert the other end of the board-to-board connector Installation and Mounting to the far left side of the unit controller or other communication module, if attached (Figure The following section describes how to field install a new BACnet IP communication module or replace an existing 8. -
Page 7: Configuring The Bacnet Communication Module
Integration Configuring the BACnet Communication Module The following section describes how to configure the BACnet 4. Modify the parameters as necessary. See Table 3 IP communication module for BAS network integration. Follow details. these instructions to set addressing parameters for the BACnet 5. - Page 8 Integration Table 3: Network Parameter Settings Parameter Range/Default Description/Notes This name must be unique throughout the entire BACnet network. The last 6 characters of Up to 17 characters Device Object Name the default are the last 6 digits of the MAC Address, which is on a printed sticker affixed to the Default: Varies BACnet communication module.
-
Page 9: Service Information
Table 3. → Make sure there are no duplicate devices on the Contact the Daikin Applied Controls Customer Support Group network (Device Name and Device ID, for example). at 866-462-7829 for additional assistance, if necessary. → Check the use of the character # at the end of each Refer to the appropriate Unit Controller Operation Manual for IP setting. -
Page 10: Appendix A: Bacnet Ip Networks
Appendix A: BACnet IP Networks Appendix A: BACnet IP Networks BACnet IP Network Types Single IP Subnet Multiple IP Subnets In BACnet/IP networks with only IP subnet (IP domain), A BACnet/IP network may consist of multiple IP subnets broadcast messages from a device (ex. 172.16.255.255 or assigned the same BACnet network number. - Page 12 Daikin Applied Training and Development Now that you have made an investment in modern, efficient Daikin equipment, its care should be a high priority. For training information on all Daikin HVAC products, please visit us at www.DaikinApplied.com and click on Training, or call 540-248-9646 and ask for the Training Department.
Need help?
Do you have a question about the BACnet MT3041 and is the answer not in the manual?
Questions and answers
Hello, I have a question: is the BAC-Net Unit MT3041 a Bacnet Server/Slave device? Best regards, Arkadij Almann
The Daikin BACnet MT3041 functions as a BACnet server device. It enables the unit controller to exchange BACnet objects with a building automation system (BAS), which is consistent with server behavior in BACnet networks.
This answer is automatically generated