Epson EcoTank M2120 Start Here

M2120
Start Here
IMPORTANT: Before using this product, make sure you read these
instructions and the safety instructions in the online User's Guide.
1
Unpack
Note:
• Do not open either of the ink bottles until you are ready to fill the ink
tank. The ink bottles are vacuum packed to maintain reliability.
• Only one ink bottle is needed to fill the ink tank at initial printer set
up. Save the remaining ink for later use.
1
Remove all protective materials from the product.
2
Raise the scanner unit. Remove all protective materials
from inside the product.
Caution: Do not touch the flat, white cable inside the printer.
3
Lower the scanner unit.
Note:
Do not turn on the product yet.
2
Fill ink tank and charge
the ink
Warning: Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution: This product requires careful handling of ink. If ink spills,
wipe it off immediately with a damp towel to avoid permanent stains. If
ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of third-party ink.
• Use one of the ink bottles included with the printer to set up the
product. Part of the ink will be used to charge the print head. This
bottle will print fewer pages compared with replacement ink bottles.
1
Connect the power cord to the back of the product and to
an electrical outlet.
Caution: Do not connect to your computer yet.
2
Press the power button to turn on the product. The
power light flashes.
3
Press the or button on the control panel to select
your language on the LCD screen, then press the OK
button.
4
When the message to see the Start Here sheet appears
on the LCD screen, raise the scanner unit. The print head
moves to the ink filling position.
5
Open the ink tank cap.