KEN BROWN KBH-5000W Manual page 7

HANGING THE HEATER
1) Lift the heater up and into the mounting bracket.
2) Align the bracket screws with the keyhole slots in the mounting bracket.
3) If the heater is to be tilted, it must be positioned in the keyhole slots. (see figure 4).
4) Tighten the bracket screws with a wrench so the unit is securely suspended at
horizontal or vertical level.
USE BOTTOM KEYHOLE
SLOTS IF HEATER IS TO
BE TILTED DOWN
ADJUSTING AIRFLOW DIRECTION
1. To turn the unit horizontally when it has been installed with a single lag bolt (as shown in
figure 3a), simply turn the entire heater as needed. (as shown in figure 5 – rotate). The unit
cannot be turned horizontally if it has been installed with 2 lag bolts.
2. To tilt the unit vertically, loosen the bracket screws (see figure 4) and see figure 6 to view
multiple vertical angles.
3. Adjust louvers to the desired position.
NOTE: The louvers are designed so they cannot be completely closed. Do not attempt to
defeat this feature; damage to the unit can result.
NOTE: To prevent possible overheating, please maintain adequate clearance as shown in
figure. 1.
BRACKET
SCREWS
Figure 4
Figure 5
REMOVE SCREW TO OPEN COVER