Installation - KEN BROWN KBH-5000W Manual

INSTALLATION

Hardware needed
You will also need the following hardware, which can be purchased from your local hardware
store or electrical supply store:
 Electric wire in the adequate gauge and length for your application;
 Proper size fuse or breaker for your heater's amperage;
 Proper wire connectors for your application;
 Fasteners appropriate for your application that are strong enough to hold the unit.
Mounting the bracket
Refer to Figures 3a and 3b.
1. Locate a wood stud in the wood ceiling joist. If you cannot locate a wood stud, you have to
install a wood piece on the ceiling as this heater must be securely fastened.
2. Remove the mounting bracket from the heating unit by loosening bracket screws with a
wrench and slipping the handle off over the screw heads.
3. Place a washer on screws before inserting through the holes in the mounting bracket and
screw them securely into a ceiling joist.
NOTE: If you want to swivel the heater either to the right or left adding a washer to both
sides of the bracket is recommended. A longer lag bolt may be required to properlysecure
the unit. See Figure 3a.
Wood Ceiling
Wood Ceiling