Menu Mode; Setting The Clock; Setting The Alarm - Cobra 29 LX Owner's Manual

Operation

Menu Mode

Menu Mode
Used to program special features. Menu/Enter
knob is used to move cursor to desired feature
Note
to program.
Use Dim/Escape button to exit
from any routine back to CB
standby mode.
Rotate Menu/Enter knob clockwise to navigate
menu levels.
Press Menu/Enter knob to select feature to be
programmed.
Level 1:
Level 3:
NB /ANL
2 3
1.5
NB/ANL CAL
SWR
ANL
S/ RF
S/RF
RF
SWR
CAL
3 5 7 9
1
SIG +30dB
SWR/CAL
VOL SQ DYNAMIKE
16
Level 2:
Level 4:
Level 5:
SCAN
EXIT
TX
MEM SCAN
RX
MEM WX !
RF GAIN DELTA TUNE T BACK

Setting the Clock

Using the clock, alarm and countdown functions.
To set the clock, press Menu/Enter knob and
select Set Clock.
12:00 PM will appear in the display and the hours
will flash. Rotate Menu/Enter knob clockwise to
select desired hour and press to set.
The minutes will then flash. Rotate Menu/Enter knob
again to select desired minutes and press to set.
Once the minutes are set, AM or PM will then
flash. Rotate Menu/Enter knob again to select AM
or PM and press to set or scroll down to EXIT and
press to return to main menu.

Setting the Alarm

Your 29 LX can be utilized as an alarm clock.
To set the alarm, press Menu/Enter knob and
select Set Alarm.
Rotate Menu/Enter knob clockwise to select Set
CH 9/
19
Alarm Time. Follow instructions above for setting
the alarm time and AM or PM.
ESC
SWR
CAL
Operation
Setting the
Clock
Note
Normal display will appear if
clock has not yet been set.
Note
Use Dim/Escape button to exit
from any routine back to CB
standby mode.
Note
The clock should be connected
to constant 12V to run
continuously.
Setting the
Alarm
17