Installing 918-5 Heavy Duty Roll Groover On 535 Threading Machine - RIDGID 918 Series Operator's Manual

Front Chuck
Carriage
Figure 6 – 918-4 Roll Groover on 1224 Threading Machine
Installing the 918-5 Heavy Duty Roll
Groover on the 535 Manual and
Automatic Threading Machines
Sub-Assembly
1. Position 918 Roll groover on the mounting base as
shown. (Figure 7)
2. Install and tighten the (2)
connect 918 to mounting base.
3. Position hydraulic pump and securely bolt in place with
" x " hex bolts.
(4) 1 / 3 /
4 4
4. Attach drive bar adapter to roll groover by tightening
two (2) set screws.
Installing on 535 Manual and Automatic Threading
Machines
1. Position carriage towards front chuck and swing car-
riage tools to the rear position.
CAUTION
pre vent accidental contact.
2. Place 918-5 on far side of carriage rail, lower onto front
rail and tighten front chuck (Figure 8).
3. Position base so that drive bar feeds into open chuck.
4. Tighten chuck jaws securely on to drive bar.
1.800.561.8187
918 Roll Groover
Drive Bar
Foot Switch
" x 1 " hex bolts which
/ /
1 1
2 4
Position reamer inside the die head to
www.
918-4
Sub-assembly
Hydraulic
" x
1 /
4
Figure 7 – 918 Roll Groover on 535 Threading Machine
Carriage
Figure 8 – 918-5 Roll Groover on 535 Threading Machine
Ridge Tool Company
.com
Drive Bar
Pump
" Bolts (4)
3 /
4
" x 1
1 / 1 /
2 4
Mounting Base
Front Chuck
Drive Bar
Foot Switch
information@itm.com
Mounting
Base
" Bolts (2)
918-5
Sub-assembly
7