Hallberg-Rassy 34.2 System Manual page 22

CHAPTER 6 - WEBASTO HEATER CONTROLS
1. There is an excellent diesel heater onboard which quickly dries out the yacht and
damp clothing. Heat transfer is via hot air, through adjustable low-level air vents in all cabins
and the heads. Vents can be regulated from fully open to fully closed and the airflow
directed. The control unit is outboard of the chart table adjacent to the electrical services
switch panel.
Controls
2. The controls and their function is shown below:
3. Caution:
•
If a fault persists or the heater suffers continuous fault cut-outs with error
messages (flashing code), it must be shut down and the power selected off. Do Not
reused until it has been inspected by a qualified engineer
•
When heater is in use, the exhaust
becomes very hot. Contact with skin,
warps or fenders will cause burns/damage.
•
Do not obstruct the air vents and
keep flammable materials well clear
•
The heater must be switched off at
refuelling stations due to the risk of
explosion
•
In the event of smoke development,
unusual combustion noises or a smell of
fuel, shut down and check the exhaust is
not obstructed.
6 - 1 Mar 20