Components
Balancer components include:
•
Display and Control Panel. Displays balance weight and mode information.
•
Inner Measuring Arm / Distance Ruler. Used to find the Distance between the Balancer
and the inner edge of the Wheel being balanced.
•
Power Switch. (Not shown.) Turns the Balancer on and off.
•
Storage Tray. Storage for Clip-On Weights and other items you want to have handy.
•
Cone Hangers . (Not shown.) Hold the MB-240X Wheel Mounting Cones when not in use.
Not all components visible in the photo above.
Balancer accessories include:
•
Quick-Release Hub Nut. Holds the Wheel on the Balancer, once the Wheel is mounted.
•
Hex Key Wrench Set. Used during installation. Hex key wrenches are sometimes called Allen®
wrenches.
•
Anchor Bolts. Anchor the Balancer to the floor at the desired location.
•
Wheel Weight Tool. Used to install and remove Clip-On Weights.
•
Weight Removal Tool. Used to remove Adhesive Weights.
•
Mounting Spring. Secures the Wheel when using Rear- and Dual-Cone Mounting.
•
Inner and Outer Gauge Calibration Weight. Used for calibrating the unit, when necessary.
•
Mounting Cone Assortment. Supports a wide range of Wheel sizes.
•
Wheel Width Calipers. Used to measure the Width of a Wheel.
•
Spacer Ring. Attaches to the Shaft Flange for larger Wheels only.
All of the Balancer accessories are shown and identified in the
MB-240X Wheel Balancer
Parts
6
section of this manual.
P/N 5900262 — Rev. A1 — Jan. 2021