Deleting Stored Stations; Deleting A Single Station; Deleting Stations During Memory Page Scan; Deleting All Stored Stations - Tecsun PL-990x Operation Manual

DELETING STORED STATIONS

Deleting a Single Station

1) Enter the memory (VM) mode and select the
station that you wish to delete.
2) Press and hold the [
until "dEL" and "PRESET" flash on the display.
3) Quick press the [
the unwanted station.

Deleting Stations During Memory Page Scan

This device can auto scan all stored stations within a memory page, staying on
each station for about 5 seconds, and giving you the opportunity to delete any
unwanted stations.
1) Select the memory page from which you wish to delete stored stations
(see also page 15 on recalling stored stations).
2) Press and hold the [ VF/VM ] button to start the memory scan.
3) Upon finding an unwanted station, press the [
confirmation is required and scanning continues immediately.
4) To stop the memory scan, gently rotate the [ TUNING ] knob.

Deleting All Stored Stations

To delete all stations within a memory page:
1) Select the memory page from which you wish to
delete all stored stations.
2) Press and hold the [
"dEL" and "PAGE" flash on the display.
3) Quick press the [
Note: In Page 0, stored stations need to be deleted for each frequency band or
mode (SYNC/SSB) separately.
] (DELETE) button
] button to delete
] (DELETE) button until
] button again to confirm.
16
] (DELETE) button. No
PAGE PRESET
PAGE PRESET