Auto Tuning Storage (Ats) - Tecsun PL-990x Operation Manual

Auto Tuning Storage (ATS)

Automatically tune into and store FM, LW, MW and SW stations.
Operation for FM and MW/LW:
1) Use the [ PAGE - ] or [ PAGE + ] button to select an (empty) memory page.
2) Quick press [ FM ] or [ MW/LW ] to select the frequency band.
3) Press and hold the [ FM ] or [ MW/LW ] button until "PRESET" flashes and
the frequency starts running.
4) When the frequency stops running, it means the ATS operation has been
completed. Rotate the [ TUNING ] knob to view all the stored stations.
Operation for SW:
1) Use the [ PAGE - ] or [ PAGE + ] button to select an (empty) memory page.
2) Quick press [ SW ] to select the SW frequency band.
3) There are two ATS modes for SW:
Mode A: Press and hold the [ SW ] or [ METER BAND - ] button to initiate
ATS for stations within all meter bands.
Mode B: Press and hold the [ METER BAND + ] button to initiate ATS within
the selected meter band.
Tips:
ATS (except in SW mode B) replaces previously stored radio stations within
a memory page. To prevent this from happening, please select an empty
memory page before initiating ATS.
ATS results for LW, MW and SW strongly depend on radio wave propagation
conditions, the receiving environment and other factors. If the results are
poor, try to initiate ATS at a different location and/or time, or tune into stations
manually and then store them.
13