Chapter 1 Quick Start
To generate a phase unlock error
To generate a phase unlock error
You can configure the function generator to generate an error condition
whenever phase lock is lost. The following steps show you how to enable
an unlock error.
Shift
1 Turn on the menu.
Menu On/Off
<
2 Move across to the
∨
<
3 Move down a level and then across to the
∨
4 Move down a level and enable the unlock error.
Enter
5 Save the change and turn off the menu.
The unlock error setting is stored in non-volatile memory, and does not
change when power has been off or after a remote-interface reset.
See also "The SCPI Status Registers" on page 23.
14
A: MOD MENU
PHASE MENU
G:PHASE MENU
4:UNLOCK ERR
ENABLE
choice on this level.
command.
UNLOCK ERR