HP 33120A User Manual page 14

Chapter 1 Quick Start
To phase lock using the triggered burst mode
Shift
6 Go to the
Menu On/Off
∨
7 Move down a level and set the burst phase.
You can set the starting phase of the burst to any value between
-360 degrees and +360 degrees. With the
the phase adjustment is not "real time"; you must exit the menu
to output the specified starting phase.
Enter
8 Save the change and turn off the menu.
The function generator beeps and displays a message to show that the
change is now in effect. You are then exited from the menu.
Next, you will configure one of the function generators to source an
external trigger from its rear-panel Ext Trig terminal.
Shift
9 On one instrument, go to the
Menu On/Off
MENU
∨
10 Move down a level and enable the external trigger.
12
command in the
BURST PHAS
6:BURST PHAS
∧000.000 DEG
ENTERED
.
3: TRIG OUT
ENABLE
MOD MENU
command,
BURST PHAS
command in the
TRIG OUT
.
PHASE