Installing The Display Panel - Dell Latitude 5320 Service Manual

NOTE: Do not pull and release the Stretch (SR) Tapes from the display panel. Separation of the brackets from the display
panel is not required.
NOTE: When removing the display panel, disengage the display panel tabs from the display cover before flipping it over for
removal.
Steps
1. Remove the two (M2x2.5) screws that secure the display panel to the display assembly.
2. Lift to turn over the display panel to access the display cable.
3. Peel the conductive tape on the display cable connector.
4. Lift the latch and disconnect the display cable from the connector on the display panel.

Installing the display panel

Prerequisites
NOTE: The display panel installation procedure is applicable only for Latitude 5320 laptop and not for the 2-in-1
configuration.
NOTE: The display panel (touch and nontouch) and its support brackets are defined as a single assembly and cannot be
further disassembled once it is removed from the display back cover. The support brackets are not to be removed from the
display panel.
NOTE: When installing the display panel, ensure that the display panel tabs are inserted into the slots on the display cover.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display panel and provides a visual representation of the installation procedure.
Removing and installing components 63