Steps
1. Place the battery on the palm-rest and keyboard assembly and align the screw holes on the battery with the screw holes on
the palm-rest and keyboard assembly.
2. Tighten the four captive screws to secure the battery in place.
3. Connect the battery cable to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Battery cable
Removing the battery cable
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
After working on your computer
before working inside your
.
computer.
Removing and installing components
25