Functional Description; General Description - Baier 50VA Instruction Manual

Functional description

3 Functional description

3.1 General description

Hint
This document describes the functionality of the 24V 50VA motor
control box. Instruction manuals for the installation of the mechanical
part of the sliding door, window or shutter are available in separate
documents.
The motor control box contains a motor control device, which is designed to drive a
24V DC motor. The motor usually drives a sliding door or a sliding shutter, to which
it is connected by a timing belt. The motor control device is controlled by potential
free inputs (Ground / Open / Close).
The motor control box comes in a splash water protected box, which dimensions
are W x H x D 17 x 14 x 8 cm³ (without wire connectors). The motor control box can
be screwed onto planar surfaces.
The motor control box contains an internal power supply unit, which provides 24 V
DC at a maximum power of 50 W. It is internally connected to the motor control
device.
For electrical connections, screw terminals are provided. For details, refer to the
mounting and connection section.
The motor control device comes with a configuration switch and two
potentiometers, to set up its operation mode. A reset key and service LEDs allow
easy initial operation.
Motor
Encoder
Control inputs
(potential free)
Permanent output 24V DC
Configurable inputs
(potential free)
Configurable output
24V DC
Relay output (optional)
Potentiometer P1 and P2
Configuration switch
Reset- and service keys
Figure 1 – Motor control box top view
24V 50VA Motor control box -
w w w . b a i e r - g m b h . d e
Version 1.0
Power Line 230 V AC
Fuse (T1A 250V)
3
Motor control device
Mounting
Power supply unit
Connections
Set up and status
display
Instruction Manual 7/20