Steps During Initial Operation - Baier 50VA Instruction Manual

Initial operation

6.2 Steps during initial operation

Moving door leaf
Danger of injury by squashing, shearing or collision, caused
by moving door leaf.
 Keep area clear during initial operation.
 Carry out electrical connections.
 Refer to chapter 5.3
 Set configuration.
 Refer to chapter 6.1
 Switch power supply on
 Control device in delivery status or after power cut:
Red LED blinks continuously twice with a short break of 1.5 sec.
 Press RESET for about 2 seconds.
 Red LED blinks continuosly.
 Check driving direction of motor with control inputs or service keys:
When pressing OPEN, door has to open and when pressing CLOSE, door has
to close.
 When driving direction is wrong:
Swap motor cables (terminals 1 and 2), check driving direction again.
 Move door in a middle position by pressing and holding the service keys.
 Press RESET for about 2 seconds
 Red LED lights up permanently
 Green LEDs (LED "open" / LED "close") light up during motor activity.
 Drive starts to move on its own.
 Door closes, opens and closes again.
 LEDs go out.
 Test, if door shows desired behavior.
 In case of malfunction check electrical connections and configuration.
 For electrical connection refer to chapter 5.3.
 For configuration refer to chapter 6.1.
 Repeat initial operation, if necessary.
 Initial operation is completed, when function is correct.
24V 50VA Motor control box -
Version 1.0
w w w . b a i e r - g m b h . d e
W A R N I N G
...
...
...
6
Prepare control device
Perform reset
Check function
Instruction Manual 17/20