Table of Contents
Advertisement
6
Initial operation
16/20
Instruction Manual
w w w . b a i e r - g m b h . d e
6.1.3 Configuration Switch
Switch
1
OFF
ON
2
3
4
5
6
7
8
Table 2 – Configuration switch
Switch 1:
Operation mode semi-automatic / automatic:
When semi-automatic mode is set the drive will not close
automatically. The potentiometer P1 is without function.
When automatic mode is set the drive closes automatically.
Switch 2:
Dead man's control:
When dead man's control is activated the drive will only operate,
as long as an input signal is applied. Switch 1 is inactive, when
dead man's control is selected.
Switch 3:
Push & Go:
With push & go enabled the drive starts to move, as soon as the
door leaf is pushed manually.
Switch 4:
Reaction on obstruction:
When reverse is set the drive stops and starts to move in the
opposite direction, as soon as an obstruction is detected.
Otherwise it will stop until a new command is given. (This is only
possible in semi-automatic mode).
Switch 5:
Closing speed:
By default the closing speed is slower than the opening speed.
The closing speed can be set as fast as the opening speed, by
setting this switch to ON.
Switch 6:
Low speed mode:
When enabled, the drive will operate generally in low speed mode.
Closing and opening speed are reduced.
Switch 7:
The combination of switches 7 and 8 sets the maximum speed of
the drive. (Refer to table 2).
Description
OFF
Semi-
Operation mode
automatic
Dead man's
-
control
Push & go
-
Reacion to
Reverse
obstruction
Reduced
Closing speed
speed
Low speed mode
-
7 OFF
7 ON
Setting of
maximum speed
7 OFF
7 ON
24V 50VA Motor control box
ON
Automatic
Enabled
(overrides
switch #1)
Enabled
Stop
Full speed
Enabled
8 OFF
80 %
8 OFF
90 %
8 ON
100 %
8 ON
60 %
- Version 1.0
Advertisement
Table of Contents
