Static Routing Table - IBM 22P6401 User Manual

2. Click Add to add a new entry in the BOOTP IP table.
v IP Address: The specified address used by the BOOTP protocol. This IP
address must be within the address pool in the DHCP server.
v MAC Address: The MAC address of the client device used for that IP
address
v Remark: The descriptions of the IP address
3. Click Apply. A new entry is added to the BOOTP IP table.
Note: The configuration changes made through the Web interface are
automatically saved into the flash memory within 30 seconds after
clicking Apply.

Static Routing table

The IBM High Rate Wireless LAN Gateway supports static TCP/IP routing. It
can serve as a router between two different TCP/IP networks (or subnets). In
the static routing table, you can exchange packets with other network
segments. The static routing table might be necessary when there are other
routers on your network and at least one of the routers is connected to more
than one network (or subnet). To route TCP/IP, do the following:
1. Click Advanced Configuration, and then click Static Routing Table to
display the static routing table.
®
6-10
IBM High Rate Wireless LAN Gateway: User's Guide