Sy-Board Section-2 - Sony ZV-1 Service Manual

4-2-3. SY-Board Section-2

Refer to "4-3. Lens Block" for disassembly/assembly of the Lens Block.
[ 7 ] Light sheild ring
Refer to "Notes on Assembling
the Light Shield Ring".
Note 1
NOTES ON HOLDING THE LENS BLOCK
Hold the Lens Block at the
center of both sides.
Hold here.
[ 1 ] Peel off the FPC-2022
flexible board
Refer to "Notes on Assembling
the FPC-2022 Flexible Board".
[ 6 ]
(Note 1)
Refer to "Notes on Assembling
the Lens Block Section (1) (2)".
[ 11 ] Insulating sheet (ST3) (63900)
Refer to "Notes on Assembling the
Insulating Sheet (ST3) (63900)".
[ 8 ] EM shield LC FPC sheet (62600)
Refer to "Notes on Assembling the
EM Shield LC FPC Sheet (62600)".
[ 9 ] Lens cushion (upper) (63900)
Refer to "Notes on Assembling the
Lens Cusion (Upper) (63900)".
[ 10 ] BT insulating sheet (64210)
Refer to "Notes on Assembling the
BT Insulating Sheet (64210)".
Do not hold the following part.
Lens barrier
*Very weak
[ 2 ] Open the SY-1112 board
[ 3 ]
Refer to "Notes on Assembling
the SY-1112 Board (1) (2)".
[ 4 ] FPC-2022 flexible board
[ 5 ] SY-1112 board
G6 lens
*Very weak
Zoom motor,
Gear B
*Very weak
Sony CONFIDENTIAL
For Authorized Servicer
31
SYS SET