NETGEAR GS348PP Installation Manual

Installation Guide
48-Port Gigabit Ethernet Unmanaged
PoE+ Switch with 24-Port PoE+ (380W)
Model GS348PP
Package contents
• Switch model GS348PP
• Power cord (varies by region)
• Rack-mount kit with four rubber feet
• Installation guide
Note: We recommend that you use Category 5e (Cat 5e) cable or higher for
Gigabit Ethernet connections.
1. Register with the NETGEAR Insight app
1. Search for NETGEAR Insight and download the latest app.
2. Set up a NETGEAR account if you do not have one.
3. Tap the menu in the upper-left corner.
4. Tap REGISTER ANY NETGEAR DEVICE.
5. Enter the serial number located on the bottom of the switch, or use the
camera on your mobile device to scan the serial number bar code.
6. Tap GO.
The switch is registered and added to your account. You can now view the
switch in the NETGEAR Insight app.
Note: Because this is an unmanaged switch, you cannot configure or manage it
in NETGEAR Insight.
2. Connect the switch
GS348PP switch
VoIP phone
Access point
Security cameras
Sample connections
3. Check the LEDs
When you connect the power cord to the switch and plug it into an electrical
outlet, the LEDs indicate the status.
The GS348PP provides PoE+ or PoE power on ports 1–24 up to 30W to each port,
with a PoE power budget of 380W across all active PoE ports.
LED
Power
Ethernet
(RJ Port in
Link/ACT
Mode)
PoE+
(RJ Port in
PoE Mode)
Fan
PoE Max
Internet
Router
Computer
LED Mode
NETGEAR, Inc.
350 East Plumeria Drive
Internet
San Jose, CA 95134, USA
PoE+
Ethernet
Description
On. The switch is receiving power.
Off The switch is not receiving power.
Green.1000 Mbps link on this port.
Blinking. 1000 Mbps activity on this port.
Yellow. 100 Mbps or 10 Mbps link on this port.
Blinking. 100 Mbps or 10 Mbps activity on this port.
Off. No link is detected on this port.
Green. PoE+ is in use.
Yellow. PoE+ halted.
Off. PoE+ is not in use on this port.
On. There is a fan error.
Off. The fan is working correctly.
Indicates the status of the switch's PoE budget:
Off. Sufficient. More than 7W of PoE power is available.
On. Less than 7W of PoE power is available.
Blinking. At least once during the previous two minutes,
less than 7W of PoE power was available.
Green. Port is in Link/Act Mode.
Yellow. Port is in PoE Mode.
NETGEAR INTERNATIONAL LTD
Floor 1, Building 3,
University Technology Centre
Curraheen Road, Cork,
T12EF21, Ireland