Reset The Room Controller To Factory Default Settings; Reset Factory Defaults Using A Switch Station - Hubbell NX Distributed Intelligence Room Controller Installation Instructions Manual

™

RESET THE ROOM CONTROLLER TO FACTORY DEFAULT SETTINGS

Should you wish to erase all manual configuration and restore the room controller to its factory default settings, perform the following step:
Simultaneously press and hold buttons A and B on the room controller. After a few seconds, LED A and B will begin alternately blink. Continue to hold
buttons A and B until the blink pattern changes to a double blink pattern. Release buttons A and B. When the blinking stops, all loads will turn on
indicating the room controller has be reset to factory default settings. After a reset, the room wil auto configure based on the connected devices.
Hint: If the installation has more than one room controller connected together in the room, the reset process done on any one of the room controllers
will reset all of the room controllers.

RESET FACTORY DEFAULTS USING A SWITCH STATION

Remove the faceplate from any wall switch and locate the rectangular opening in the plastic bezel marked "SVC PIN". Use a thin object such as a
straightened paper clip to press the recessed configuration button for at least 10 seconds. Note that the button is located slightly offset from the
opening in the bezel. The LED marked "SVC" will blink while the configuration button is being pressed. Release the configuration button and note
that all loads in the room turn on indicating that the room has been reset to factory default settings.
72-00646
701 Millennium Blvd. | Greenville, SC 29607 | (864) 678-1000 | (866) 898-0131 - fax www.hubbellcontrolsolutions.com
Copyright © 2018 Hubbell Control Solutions, a division of Hubbell Lighting, Inc. All rights reserved. All product and company names, logos and product
identifiers are trademarks ™ or registered trademarks ® of Hubbell Lighting, Inc. or their respective owners. Use of them does not necessarily imply any
3451B 082918
affiliation with or endorsement by such respective owners.