Table of Contents
Advertisement
TOOLS REQUIRED
Phillips screwdriver
WARNING: DUE TO THE WEIGHT OF THE STOVE IT IS RECOMMENDED
THAT TWO PEOPLE PERFORM THE UNPACKING AND ASSEMBLY.
Unpack the stove and remove packing materials. Open the doors and
remove the grate, ashpan, legs, Flue with flue adaptor and fixings kit from
inside the stove.
1. Place the stove on a soft surface
such as the polystyrene packing
materials from the crate and tilt the
stove back.
2. Attach the legs using the bolts and
large washers supplied as shown in
Fig 1.
3. Sit the stove upright and attach the
flue adaptor as shown in Fig 2 using
the screws supplied. Ensure the
fireproof gasket is correctly seated
in the base of the flue adaptor.
4. Check that the blanking plate is
installed in the rear panel of the
stove when the normal flue exit is
required.
• If the rear mounting flue
configuration is to be used, the
blanking plate will be fitted to the
top of the stove and the flue
connector to the rear panel.
5. Set the grate and ashpan in
position as in Fig 3. A handle is
supplied for when the stove is in
use.
5. Place stove in the desired location
as shown in POSITIONING AND
INSTALLATION. Take care not to
damage the floor surface.
Note; All stoves must be installed in
accordance with the local building
regulations.
13mm spanner
4
Fig 3
Advertisement
Table of Contents
