FLOS ROMEO MOON/SOFT F Instruction For Correct Installation And Use

INSTRUCTION FOR CORRECT INSTALLATION AND USE
WARNING!
The safety of this appliance can only be guaranteed if these instructions are followed during installation and use. Therefore,
please keep a copy of these instructions for later reference.
REMARKS
- Make sure the mains power supply has been disconnected before installing the appliance or carrying out any work on
it.
- If not familiar with electrical connections, contact a qualified electrician.
- The appliance may in no way be modified or tampered with, any modification may compromise safety causing the
appliance to become dangerous. FLOS declines all responsibility for products that are modified.
TECHNICAL DATA
USA VERSION - Halogen incandescent lamp Max. 150W E26 coupling type T.
120V VERSION - Halogen incandescent lamp Max. 250W E26 coupling type T.
JAP VERSION - Halogen incandescent lamp Max. 250W E26 coupling type T.
CLEANING INSTRUCTIONS
- Use only a soft cloth to clean the appliance, dampened with water and soap or mild cleanser if needed for resistant dirt.
- Warning: do not use alcohol or other solvents.
A
Fig.1
Fig.1 Loosen the three screws on the steam base (A). Insert the screws into keyhole slots in base (B) and turn clockwise.
Tighten the three screws securely.
Fig.2 Take the fixture stem and pass the cord (C) with dimmer through the hole of the base plate. Feed the cord (C) through
the slot in the base and then snap the cord (C) into the clip. Place the fixture on the floor.
Fig.3 Position the plastic ring (D) onto the three support arms (E). For the Romeo Moon glass shade, use the flat-head
screws (F) to fasten the plastic ring (D) to the support arms (E).
FLOSUSA
UL Listed
C-UL Listed
ROMEO MOON/SOFT F
B
B
Fig.2
A
C
Fig.3
1
D
E
02-28-06 Cod.08090
F