Setting Data Rates - Black Box IC128C-R3 Manual

Pc plus adapter dual serial pci

Hide thumbs Also See for IC128C-R3:

Table of Contents

PC PLUS ADAPTER DUAL SERIAL PCI

The Resources (Com Address and IRQ) used by the

individual ports on the Adapter cannot be modified. Interrupt

Resources may be modified in the Parent (see Device

Manager), but not for individual ports because both ports on

the Adapter share one IRQ. Interrupt changes require a

reboot to take effect.

The Com Port designation number of each of the

Adapter's ports may be changed in software. If you wish

to modify the Com numbering of either port on the

Adapter (for example, Renaming Com 5 to be Com 4),

use the Redirect utility in the Utils subdirectory on your

diskette. See Section 5.1.5.

5.1.2 S

ETTING

You can set the data rate of the Adapter using the Bits

per Second pull-down menu.

This menu will also appear when setting the "Port

Properties" in any communications application, and may

have to be set independently of your Control Panel settings.

Control Panel settings may not necessarily be linked to

those of your communications application. For example,

Port speeds in Dial-Up Networking are controlled

independently of speed settings in Device Manager.

ATA

ATES

NOTE

Table of Contents