Subscribe to Our Youtube Channel
Related Manuals for Black Box IC904C
Summary of Contents for Black Box IC904C
- Page 1 (217) 352-9330 | Click HERE Find the Black Box IC904C at our website:...
- Page 2 Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...
- Page 3 8 INPUT/8 OUTPUT PCI CARD FEDERAL COMMUNICATIONS COMMISSION INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference...
- Page 4 8 INPUT/8 OUTPUT PCI CARD EMC Directive Statement Products bearing the CE Label fulfill the requirements of the EMC directive (89/336/EEC) and of the low-voltage directive (73/23/EEC) issued by the European Commission. To obey these directives, the following European standards must be met: •...
- Page 5 8 INPUT/8 OUTPUT PCI CARD NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY STATEMENT INSTRUCCIONES DE SEGURIDAD 1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.
- Page 6 8 INPUT/8 OUTPUT PCI CARD 10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor. 11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como se indique en el aparato.
- Page 7 8 INPUT/8 OUTPUT PCI CARD TRADEMARKS USED IN THIS MANUAL Windows is a registered trademark of Microsoft ® Corporation. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.a...
-
Page 8: Table Of Contents
8 INPUT/8 OUTPUT PCI CARD CONTENTS 1. Specifications......8 1.1 Environmental Specifications... . . 8 1.2 Power Consumption . - Page 9 8 INPUT/8 OUTPUT PCI CARD 4.4 Output Port (Reed Relay) Pin Assignments (P3 DB37 Male) ......17 4.5 Power and Ground Pin Assignments (P3 DB37 Male) .
-
Page 10: Specifications
8 INPUT/8 OUTPUT PCI CARD 1. Specifications Temperature Tolerance—Operating: 32 to 122°F (0 to 50°C); Storage: -4 to +158°F (-20 to +70°C) Humidity —10 to 90%, noncondensing Supply line—+5 VDC MTBF—Greater than 150,000 hours (calculated) Connectors—(1) DB37 male Power—10 to 29 mA (19 mA factory default), +5 VDC Size—3.9"H x 5"L (9.9 x 12.7 cm) including goldfingers;... -
Page 11: Introduction
2.2 What’s Included The 8 Input/8 Output PCI Card comes with the following items. If anything is missing or damaged, please contact Black Box at 724-746-5500. • (1) 8 Input/8 Output PCI Card • (1) 3.5" diskette containing DIO Software •... -
Page 12: Technical Description
8 INPUT/8 OUTPUT PCI CARD 2.3 Technical Description The 8 Input/8 Output PCI Card provides two parallel input/output (I/O) ports. The ports are organized as ports A, B, C, and D. Port A is an input port interfaced to optically isolated inputs, while port C is the reed-relay output port. - Page 13 8 INPUT/8 OUTPUT PCI CARD to a common ground) from every other sensor, and also isolated with respect to the host PC ground. This means that signals such as low-voltage AC, motor-servo voltage, and control-relay signals can be “sensed,” (or read) by the PC without risking damage caused by ground loops or ground faults.
- Page 14 8 INPUT/8 OUTPUT PCI CARD When selecting the input resistor, consider: 1. Power-on voltage for the circuit to sense. 2. The maximum input voltage. Maximum input voltage must not overload the input resistor, and must not overdrive the opto-isolator input-current specification.
- Page 15 8 INPUT/8 OUTPUT PCI CARD Input Resistor Value Power-On Max. Input Range Max. Current (Ohms) (Volts) (Volts) (mA) 1.76 to 7.4 2 to 6 560* 2.8 to 11.8 3 to 12 4.1 to 15 4 to 16 2.2K 7.7 to 23.4 8 to 24 *Factory default Increasing the input resistor can increase the maximum...
-
Page 16: Installation
8 INPUT/8 OUTPUT PCI CARD 3. Installation 3.1 Card Setup The 8 Input/8 Output PCI Card is a fully compliant PCI “plug-and-play” adapter. All card resources (such as I/O address and IRQ selection) are auto-assigned by either your system BIOS or your plug-and-play operating system. - Page 17 8 INPUT/8 OUTPUT PCI CARD 3. Locate an available PCI slot and remove the screw that secures the blank metal slot cover. Remove the cover. 4. Gently insert the PCI Card into the slot. Make sure that the Card is seated properly. 5.
-
Page 18: Additional Information
8 INPUT/8 OUTPUT PCI CARD 4. Additional Information 4.1 Sensor Input Port Pin Assignments (P3 DB37 Male) Port A Bit 2,20 3,21 4,22 5,23 6,24 7,25 8,26 9,27 4.2 Output Port (Reed Relay) Reed relays provide very high quality, long life, low current (0.5 amps max.), dry-contact switch closures. -
Page 19: Output Port (Reed Relay) Pin Assignments
8 INPUT/8 OUTPUT PCI CARD • Contact Voltage Maximum: 100 Volts DC or AC maximum • Contact Current Maximum: 0.5 Amps DC or AC • Contact Resistance, Initial: 0.15 Ohms • Rated Life: Low Load: 200 million closures; Maximum Load: 100 million closures •... -
Page 20: Power And Ground Pin Assignments
8 INPUT/8 OUTPUT PCI CARD 4.5 Power and Ground Pin Assignments (P3 DB37 Male) Ground 18,36,37 + 5 Volts + 12 Volts 4.6 Software The 8 Input/8 Output PCI Card ships with an I/O suite of Windows 95, 98, and NT drivers. The software ®... -
Page 21: Register Description
8 INPUT/8 OUTPUT PCI CARD 4.7 Register Description Address Mode Base+0 RD/WR PAD7 PAD6 PAD5 PAD4 PAD3 PAD2 PAD1 PAD0 Base+1 Base+2 RD/WR PCD7 PCD6 PCD5 PCD4 PCD3 PCD2 PCD1 PCD0 Base+3 Base+4 Base+5 RD/WR IRQEN IRQST IRC1 IRS0 Base+6 Base+7 Technology Group - Quality Instrumentation ... -
Page 22: Appendix A: Troubleshooting
8 INPUT/8 OUTPUT PCI CARD Appendix A. Troubleshooting A.1 Read This First Following these simple steps can eliminate most common problems without calling Technical Support. 1. Install the software first. After installing the software, add the hardware. This places the required installation files in the correct locations. -
Page 23: Calling For Technical Support
8 INPUT/8 OUTPUT PCI CARD A.2 Calling for Technical Support If the troubleshooting suggestions listed in Section A.1 do not solve your problem, call Black Box Techncial Support at 724-746-5500. When calling for technical support, please have your user manual and current adapter settings. -
Page 24: Appendix B: Block Diagram
8 INPUT/8 OUTPUT PCI CARD Appendix B. Block Diagram Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.a... - Page 25 © Copyright 2000. Black Box Corporation. All rights reserved. 1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746 Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.a...
Need help?
Do you have a question about the IC904C and is the answer not in the manual?
Questions and answers