Cessna 150 Series Service Manual page 93

d. (Refer to figure 6-3.)
Adjust turnbuckles at f. Safely all turnbuckles by the single-wrap method
bellcranks (11) so stop bushings (17) are centered using 0.040-inch monel safety wire.
in bellcrank slots with 40
*
10 pounds tension on
g. Remove bar from control wheels and install all
carry-thru cable (16). Disregard tension on direct parts removed for access.
cables, which will be different than tension on carry- h. Check ailerons for correct travel using inclino-
thru cable.
meter. Refer to figure 1-1 for travel specifications.
e.
Adjust push-pull rod (7) at each aileron until
ailerons are neutral with reference to the trailing
WARNING
edge of wing flaps.
Be sure wing flaps are fully
up when making this adjustment.
Tighten push-pull
Be sure ailerons move in correct direction
rod jam nuts.
when operated by control wheel.
SHOP NOTES:
Change 1
6-7/(6-8 blank)