Cessna 150 Series Service Manual page 30

OILITE BEARINGS
NEEDLE
(RUDDER BAR ENDS)
BEARINGS
ALL LINKAGE
GR
POINT PIVOTS
RUDDER BARS AND PEDALS
NEEDLE
BEARINGS
REFER TO
PARAGRAPH 2-44 ELECTRIC FLAP
DRIVE MECHANISM
NOTES
Sealed bearings require no lubrication.
Do not lubricate roller chains or cables except under seacoast conditions. Wipe with a clean,
dry cloth.
Lubricate unsealed pulley bearings, rod ends, Oilite bearings, pivot and hinge points, and any
other friction point obviously needing lubrication, with general purpose oil every 1000 hours or
oftener if required.
Paraffin wax rubbed on seat rails will ease sliding the seats fore and aft.
Lubricate door latching mechanism with MIL-G-81322A general purpose grease, applied sparingly
to friction points, every 1000 hours or oftener, if binding occurs. No lubrication is recommended
on the rotary clutch.
Figure 2-5. Lubrication (Sheet 3 of 3)
2-17