9: Connecting With Existing Z-Wave Network; Adding/Removing To/From Existing Z-Wave Network; Copying Network Information Between Controllers - Nice FIBARO YH-001 User Manual

9: CONNECTING WITH EXISTING Z-WAVE
NETWORK
9.1: ADDING/REMOVING TO/FROM EXISTING Z-WAVE
NETWORK
This gateway can be added to an existing Z-Wave network only if no
Z-Wave devices are added to it.
1. Start adding/removing procedure on the primary controller (according
to its manual).
2. Go to > Z-Wave.
3. Under Start Learn Mode
4. If you are prompted for the PIN, you will find it on the bottom of the
gateway and on the box.
9.2: COPYING NETWORK INFORMATION BETWEEN
CONTROLLERS
Copying network information (Replication) is the process of updating
network information from a primary controller to secondary controllers,
such as node list and routing information.
These steps are usually not required unless you have a multiple controller
network.
Copying information from this controller to the secondary
controller
1. Start adding procedure according to chapter "Adding using Inclusion
Mode" on page 7.
2. Start Learn Mode on the secondary controller (according to its
manual).
3. After couple of minutes both controllers will have the same network
information.
Copying information to this controller from the primary controller
1. Start adding procedure on the primary controller (according to its
manual).
2. Go to
> Z-Wave.
3. Under Start Learn Mode
4. After couple of minutes both controllers will have the same network
information.
click Start
click Start
connectIng WIth exIstIng Z-Wave netWork
17