Glen Dimplex CST Owner's Manual

Glen Dimplex CST Owner's Manual

High output fan-forced heater, fan-forced heater

Advertisement

OWNER'S GUIDE
Fan-forced
heater (CS)
Thank you for your purchase! Question or problem? Let us solve it with a single
phone call, email or online chat! We'll save you a trip back to the store!
Customer Service:
Phone: 888-346-7539 (from US or Canada)
Email: cs@glendimplexamericas.com
Assembled in USA
gdaheat.com
High output
fan-forced
heater (CST)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CST and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Glen Dimplex CST

  • Page 1 OWNER’S GUIDE High output fan-forced heater (CST) Fan-forced heater (CS) Thank you for your purchase! Question or problem? Let us solve it with a single phone call, email or online chat! We’ll save you a trip back to the store!
  • Page 2: Important Instructions

    IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before install- 6. To disconnect heater, turn control(s) ing or using this heater. to off, and turn off power to heater cir- 2.
  • Page 3: Installation Instructions

    INSTALLATION INSTRUCTIONS 1. All electrical work and materials Model CST - wall can model must comply with the National CTC (WC1) Electric Code (NEC), the Occu- 5. DO NOT install the heater in a floor, pational Safety and Health Act...
  • Page 4 If you already have drywall installed, place the can into the cutout so the front is flush with the drywall. Fasten the wall can to the stud with 2 screws (Model CS) or 4 screws (Model CST) (not included), through holes provided in the wall can (Figure 3). As an option on model CS, the foam pad provided may be attached to the side of the wall can to square the wall can to the stud (See Figure 3).
  • Page 5: Install Grill

    INSTALLATION INSTRUCTIONS INSERT THE HEATER ASSEMBLY IN THE WALL CAN STEP 4 Wire connections 1. Your heater has two connection wires on the back. Your supply wire has two connection wires and a supply ground wire. . Connect supply ground wire to grounding screw in wall can (See Figure 4 or 5).
  • Page 6: Warranty

    Replacement or er will repair or replace any Fan-forced (CS) or repair of any product or part does not create any High-output Fan-forced (CST) heater found to be new warranties. defective within two years after the date of pur- chase.
  • Page 7: Complete Installation

    Contact your local recycling support center for further recycling WITH SINGLE-POLE WALL THERMOSTAT ALTERNATE instructions. To/From Heater To/From Heater To/From Heater Model CST Model CS High-temperature safety shutoff High-temperature safety shutoff High-temperature safety shutoff INTERNAL HEATER WIRING DIAGRAMS Heating Element...
  • Page 8: Maintaining Your Heater

    Any service other than cleaning should be performed by an authorized service representative. High-temperature safety shutoff All CS and CST fan-forced heaters come with built-in high-temperature safety shutoffs that stop electricity flowing to the heater if it gets too hot inside. See TROUBLESHOOTING below if you’re experiencing problems with your heater.

This manual is also suitable for:

Cs

Table of Contents