Operation; Settings - Festool CTL 48 E LE EC/B22 Original Operating Manual

CTM 48 E LE EC/B22, CTL 48 E LE EC/B22
GB
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
6.1 Initial operation

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Remove the accessories from the dust contain-
er [2-3] and the packaging!

Insert a filter bag in the dust container that ful-
fils statutory requirements (see chapter 7.8).

Replace the top section [2-1] and close the
locking clips [2-2].

Attach the cable holder to the rear of the mobile
dust extractor (see Fig. [3]).

Insert the sealing plug [1-1] on the panel (see
Fig. [1] ).

Connect suction hose at the extractor opening
[1-2].
6.2 Switch on/off

Insert the plug into an earthed socket.
The use of extension cables in Zone 22 is not
permitted.
CAUTION
Risk of injury from tools starting up unexpectedly

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket [1-11] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-11] is connected to the power,
the mobile dust extractor starts.
16
"Auto" switch position
Appliance socket [1-11] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.
7

Settings

7.1 Adjusting the hose diameter

Adjust the hose diameter adjuster [1-8] to
match the diameter of the connected hose.
 The monitoring devices will measure the air
speed in the extractor hose correctly as a result
(see chapter 7.9).
7.2 Connecting electric power tools
WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-11].
7.3 Connecting pneumatic tools
WARNING
Risk of injury

Switch off the air tool.
With the compressed air module [1-3], the auto-
matic switch-on function for the mobile dust ex-
tractor also works in conjunction with air tools.
We also recommend installing the VE service unit
(495886). The service unit filters and lubricates the
compressed air and enables an adjustment of the
air pressure. An IAS adapter (454757) is available to
connect Festool air tools to the IAS system.
The operating pressure of the tool must be 6 bar for
the automatic switch-on unit to function correctly.
7.4 Connecting the energy box
The connection for the energy box (EAA) [1-4] al-
lows you to connect the mobile dust extractor with
the EAA in order to couple the automatic switch-on
unit on the mobile dust extractor with the equiva-
lent unit on the EAA.
7.5 Adjusting the suction power

Use the rotary knob [1-10].
7.6 Applying the brake
Folding out the black brake lever [1-15] prevents
the mobile dust extractor from rolling. To achieve
this, lift the front end of the mobile dust extractor