Canon PIXMA MX870 Service Manual page 18

##111 TX / RX Memory error
##114 RX RTN has been received.
##200 RX A carrier has not been detected for 5 seconds during image
reception.
##201 TX / RX DCN has been received in a method other than the binary
procedure.
##204 TX DTC has been received even when there is no sending data.
##220 TX / RX System error (main program hang-up)
##224 TX / RX An error has occurred in the procedure signal in G3
transmission.
##226 TX / RX The stack pointer has shifted from the RAM area.
##229 RX The recording area has been locked for 1 minute.
##232 TX The encoder control unit has malfunctioned.
##237 RX The decoder control unit has malfunctioned.
##238 RX The print control unit has malfunctioned.
##261 TX / RX A system error has occurred between the modem and the system
control board.
##280 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##281 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##282 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##283 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##284 TX After TCF transmission, DCN has been received.
##285 TX After EOP transmission, DCN has been received.
##286 TX After EOM transmission, DCN has been received.
##287 TX After MPS transmission, DCN has been received.
##288 TX After EOP transmission, a signal other than PIN, PIP, MCF,
RTP, RTN has been received.
##289 TX After EOM transmission, a signal other than PIN, PIP, MCF,
RTP, RTN has been received.
##290 TX After MPS transmission, a signal other than PIN, PIP, MCF,
RTP, RTN has been received.
##670 TX In V.8 late start, the DIS V.8 ability from the receiving machine
was detected, and CI was sent in response; however, the
procedure failed, causing T1 time-over.
15 / 63
- Eliminate all the data, and
register them again.
- Increase the transmission level of
the sending machine.
- Increase the transmission level of
the sending machine.
- Set the other machine ready for
reception.
- Turn the machine off, and turn it
on again
- Modular board
- Logic board
- Turn the machine off, and turn it
on again.
- After the area is unlocked, print
the recorded image.
- Modular board
- Logic board
- Modular board
- Logic board
- Modular board
- Logic board
- Modular board
- Logic board
- Try a higher transmission level.
- Try a higher transmission level.
- Try a higher transmission level.
- Try a higher transmission level.
- Set the receiving machine ready
for reception.
- Re-send the fax.
- Re-send the fax.
- Re-send the fax.
- In bit 0 of the service data #1
SSSW SW28, prohibit the V.8 /
V.34 procedure of the sending