Generic Functions - Mutec MC-3+ Smart Clock Operating Manual

Operation
»HOLD«
This red LED lights when the external reference clock signal is interrupted or lost. The frequency synthesizer of the MC-3+ kee-
ps generating all output signals continuously, based on the last incoming clock rate. Thus, your studio set-up receives non-in-
terrupted clock supply, regardless if a valid external referecne signal is present, unstable or lost. Re-synchronization is carried
out without affecting any of the outputs signals critically.
»AUDIO«
This red LED lights when a valid AES3/11 or S/P-DIF optical or coaxial digital audio reference signal is detected at the corre-
sponding input.
CLOCK IN
Supported Input Clock Rates at the WCLK IN
32.0 kHz 44.1 kHz
176.4 kHz 192.0 kHz

Generic Functions

There are two additional functions which influence the working of your whole MC-3+:
Front Panel lock out + LED shut down
When pressing both front panel keys together at one time, all LEDs will shut down except the »POWER« and »LOCK« LEDs.
Additionally, the functions of both keys are also blocked to prevent unauthorized operation, which is important during e.g. live
events.
During that state of operation, pressing only one of both keys let every appropriate LED light according the device's settings as
long as the key is pressed. Thus, you can check easily the device's settings without unlocking the device finally.
To reactivate the keys and the LEDs, please press both keys for apperox. four seconds until all LEDs light again.
Factory Reset
You can reset the operating system of your MC-3+ to the initial status by switching on the unit while pressing the »MENU«
key simultaneously.
48.0 kHz 88.2 kHz
10.0 MHz 11,289.6 MHz
This area displays the clock rate of
the incoming clock or digital audio
reference signal. The following basis
reference clock rates are supported and
will be analyzed.
96.0 kHz
12,288.0 MHz
17