Electric Brake; Installing The Handle - Makita DUR190U Instruction Manual

Speed indicator
NOTE: When you set ADT (Automatic Torque Drive
Technology), ADT indicator turns on and the tool runs
at optimum rotation speed and torque for the condi-
tion of grass being cut.
Reverse button for debris removal
WARNING:
Switch off the tool and remove
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris entan-
gled in the tool.
To reverse the rotation, tap the reverse button and pull
the switch trigger while depressing the lock-off lever
when the cutting tool is stopped. The speed indicators
and ADT indicator start blinking, and the cutting tool
rotates in reverse direction when you pull the switch
trigger.
To return to regular rotation, release the trigger and wait
until the cutting tool stops.
1
► 1 . Speed indicator 2. ADT indicator 3. Reverse
button
Mode Rotation speed
ADT 3,500 - 6,000 min
High 6,000 min
Medium 5,100 min
Low 3,500 min
2
NOTE: During the reverse rotation, the tool operates
only for a short period of time and then automatically
-1
stops.
NOTE: Once the tool is stopped, the rotation returns
-1
to regular direction when you start the tool again.
NOTE: If you tap the reverse button while the cutting
tool is still rotating, the tool comes to stop and to be
ready for reverse rotation.
-1

Electric brake

This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
-1
is released, have the tool serviced at our service center.
CAUTION:
tute for the protector. Never use the tool without
the protector. An unguarded cutting tool may result
in serious personal injury.
ASSEMBLY
WARNING:
switched off and battery cartridge is removed
before carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
WARNING:
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.

Installing the handle

For DUR190U and DUR191U only
1.
Insert the shaft of the handle into the grip. Align
the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
2
3
► 1 . Grip 2. Screw 3. Handle
14 ENGLISH
This brake system is not a substi-
Always be sure that the tool is
Never start the tool unless it is
1
3