Wiring Instructions; Replacement Parts And Accessories - Ecco EB7800 Series Installation Instructions Manual

Wiring Instructions:

Important!
Disable power before wiring the beacon.
The wiring is as shown in FIGURE 4. All wiring should be a mini-
mum of 18AWG. The positive line must have a 5 amp
fuse, as shown. A switch may be used to control the on/off func-
tion. Route the ground wire directly back to negative battery
terminal. Pack dielectric grease, such as Dow Corning 4, around
each electric connection exposed to moisture or the ambient
environment. For a 24 VDC system, remove the lens, move the
belt to the upper slot on the pulley as shown in FIGURE 5 and
reattach the lens.
FUSE (5 AMP)
(USER SUPPLIED)
(+) (-)
BATTERY
GROUND
PULLEY
FIGURE 5
Note:
Operating the vehicle without the lens installed on this product
will result in damage that will not be covered under warranty.
SWITCH
(USER SUPPLIED)
FIGURE 4

Replacement Parts and Accessories:

Description
Replacement Lens, Amber
Replacement Belt
"L" Bracket (for Quick Connect mounting)
"T" Bracket (for Quick Connect mounting)
*Available colors include A: Amber, B: Blue, & R: Red
BELT
Part Number
R5810LA
R5801B
A5850LB
A5850TB
Page 3 of 4