Wiring Instructions; Maintenance And Troubleshooting; Customer Service - Ecco 6260 Series Installation And Operation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Important: Disable power before wiring up the LED beacon.

Wiring Instructions:

The unit is designed for electrical systems from 12 to 80 VDC (9 to 86 VDC
extremes). The wiring for all systems is:
Red Wire Positive (+)
Black Wire Negative (-)
All wiring should be a minimum of 18 AWG. A 3-amp fuse in the positive line is
required (see Figure 1). A switch may be used to control the on/off function of
the LED beacon. Note: For model 6263, wires will come from bottom, not side as
Figure 1 shows. Still follow same wiring instructions.
!
NOTE: Operating the vehicle without the outer lens installed on the product may result in damage that will NOT be covered under warranty.
Manufacturer Limited Warranty and Limitation of Liability:
Manufacturer warrants that on the date of purchase, this product will conform to Manufacturer's specifications for this product (which are
available from the Manufacturer upon request). This Limited Warranty extends for thirty-six (36) months from the date of purchase.
DAMAGE TO PARTS OR PRODUCTS RESULTING FROM TAMPERING, ACCIDENT, ABUSE, MISUSE, NEGLIGENCE, UNAPPROVED
MODIFICATIONS, FIRE OR OTHER HAZARD; IMPROPER INSTALLATION OR OPERATION; OR NOT BEING MAINTAINED IN ACCOR-
DANCE WITH THE MAINTENANCE PROCEDURES SET FORTH IN MANUFACTURER'S INSTALLATION AND OPERATING INSTRUC-
TIONS VOIDS THIS LIMITED WARRANTY.
Exclusion of Other Warranties:
MANUFACTURER MAKES NO OTHER WARRANTIES, EXPRESSED OR IMPLIED. THE IMPLIED WARRANTIES FOR MERCHANT-
ABILITY, QUALITY OR FITNESS FOR A PARTICULAR PURPOSE, OR ARISING FROM A COURSE OF DEALING, USAGE OR TRADE
PRACTICE ARE HEREBY EXCLUDED AND SHALL NOT APPLY TO THE PRODUCT AND ARE HEREBY DISCLAIMED, EXCEPT TO
THE EXTENT PROHIBITED BY APPLICABLE LAW. ORAL STATEMENTS OR REPRESENTATIONS ABOUT THE PRODUCT DO NOT
CONSTITUTE WARRANTIES.
Remedies and Limitation of Liability:
MANUFACTURER'S SOLE LIABILITY AND BUYER'S EXCLUSIVE REMEDY IN CONTRACT, TORT (INCLUDING NEGLIGENCE), OR
UNDER ANY OTHER THEORY AGAINST MANUFACTURER REGARDING THE PRODUCT AND ITS USE SHALL BE, AT MANUFAC-
TURER'S DISCRETION, THE REPLACEMENT OR REPAIR OF THE PRODUCT, OR THE REFUND OF THE PURCHASE PRICE PAID BY
BUYER FOR NON-CONFORMING PRODUCT. IN NO EVENT SHALL MANUFACTURER'S LIABILITY ARISING OUT OF THIS LIMITED
WARRANTY OR ANY OTHER CLAIM RELATED TO THE MANUFACTURER'S PRODUCTS EXCEED THE AMOUNT PAID FOR THE
PRODUCT BY BUYER AT THE TIME OF THE ORIGINAL PURCHASE. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR LOST
PROFITS, THE COST OF SUBSTITUTE EQUIPMENT OR LABOR, PROPERTY DAMAGE, OR OTHER SPECIAL, CONSEQUENTIAL,
OR INCIDENTAL DAMAGES BASED UPON ANY CLAIM FOR BREACH OF CONTRACT, IMPROPER INSTALLATION, NEGLIGENCE, OR
OTHER CLAIM, EVEN IF MANUFACTURER OR A MANUFACTURER'S REPRESENTATIVE HAS BEEN ADVISED OF THE POSSIBILITY
OF SUCH DAMAGES. MANUFACTURER SHALL HAVE NO FURTHER OBLIGATION OR LIABILITY WITH RESPECT TO THE PRODUCT
OR ITS SALE, OPERATION AND USE, AND MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES THE ASSUMPTION OF ANY
OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH SUCH PRODUCT.
This Limited Warranty defines specific legal rights. You may have other legal rights which vary from jurisdiction to jurisdiction. Some jurisdic-
tions do not allow the exclusion or limitation of incidental or consequential damages.
©2012
920-0312-00 Rev. D
NOTE: THIS UNIT IS REVERSE POLARITY PROTECTED
AND WILL NOT OPERATE IF WIRED BACKWARD.
Figure 1
WARNING!
The LED beacon power supply is a high voltage device. To avoid the risk of
electrical shock, turn off power before removing lens. There are no internally
serviceable parts.
Maintenance & Troubleshooting:
1. Most LED beacon failures, including intermittent or erratic operation as well
as failure of operation can be traced to wiring or battery problems. Check
all wiring, connections, fuse, switch, and battery voltage to insure that the
correct voltage is reaching the LED beacon.
2. If this has not remedied the problem, return product to your local dealer for
warranty replacement, or call ECCO Customer Service for assistance.
Replacement Parts & Accessories:
Description
Lens, 4"
Lens Gasket
Branch Guard
*where X indicates color: A = Amber, B = Blue, C = Clear, G = Green,
R = Red
Part Number
R6260LX*
R6220GL
A6200BG
833 West Diamond St
Boise, Idaho 83705

Customer Service

USA 800-635-5900
UK +44 (0)113 237 5340
AUS +61 (0)3 63322444
www.eccoesg.com
Page 2 of 2

Advertisement

Table of Contents
loading

This manual is also suitable for:

626262636267

Table of Contents