Safety Rules - Hoffmann PP2 Operating Manual

Hoffmann PP2 Dovetail Routing Machine

2. Safety Rules

Read and understand these safety rules before operating this machine!
1. Always disconnect the machine from the electrical power supply and from compressed air
supply before attempting any adjustment, repair or maintenance procedure (change of router
bit, depth-of-cut adjustment, removal of wood dust, etc.).
2. Do not allow power cord or air hose to lay on the floor, in the way of passing personnel or the
machine operator. They will cause a trip hazard.
3. Always wear eye and ear protection as well as a respirator suitable for wood dust.
4. Remove or confine loose hair, clothing and jewelry to avoid entanglement.
5. Avoid a dangerous environment. Do not expose electrical equipment to rain. Do not use in
presence of flammable liquids or gases.
6. Keep the area around the machine clean and free from scrap, sawdust, wood chips, oil and
grease to avoid the danger of slipping.
7. Always use a suitable dust collection system. Duct must be properly connected to the dust
extraction port at the back of the machine.
8. Use only sharp and flawless original Hoffmann router bits.
9. Check the machine upon receipt as well as before every use for improper functioning and
worn or damaged parts. Make sure the appropriate router bit is securely installed.
10. Broken or defective parts must not be used until replaced or repaired by a qualified
technician.
11. When interrupting work or upon leaving the area, machine must be switched off.
12.
Only trained and qualified personnel must be allowed to use machine.
13.
Only original Hoffmann replacement parts must be used to rebuild machine.
Hoffmann Machine Company, Inc.
Phone: (828) 430 - 4510
- 2 -
1386 Drexel Road
Fax: (828) 430 - 4620
www.Hoffmann-USA.com
Valdese, NC 28690
e-mail: info@Hoffmann-USA.com