Hoffmann PP2 Operating Manual page 8

Hoffmann PP2 Dovetail Routing Machine
9.3 Miter joints with angles other than 45 degrees
Replace the standard 45-degree steel fence plate (shipped with machine) with either a fixed fence plate for
hexagon or octagon frames, or the adjustable Hoffmann Synchro fence and proceed as outlined in section
9.2.
The square stop (1) can also be used to machine miter joints with any given angle.
The square stop (1) is set to the desired position and locked in place. All material is machined on its right
end miters with this setting.
The square stop is then moved to the other side of the table, and the same position is set with the aid of the
tape scale (2).
With both settings being equal, a perfectly aligned corner is achieved.
9.4 Butt-joints with square cut ends (e.g. face-frame construction, round parts)
Remove the steel fence plate from the machine table and use the supplied square aluminum stop
(1) instead. Recessed in the machine table is a tape scale (2), with is used to adjust these stops.
Hoffmann Machine Company, Inc.
Phone: (828) 430 - 4510
- 7 -
1386 Drexel Road
Fax: (828) 430 - 4620
www.Hoffmann-USA.com
Valdese, NC 28690
e-mail: info@Hoffmann-USA.com