Philips FW-V39 Manual page 7

All manuals and user guides at all-guides.com
A AM Loop Antenna
Connection
Connect the supplied loop antenna to the
AM ANTENNA terminal. Place the AM loop
antenna far away from the system and
adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to
the FM AERIAL (FM ANTENNA) 75 Ω
terminal. Adjust the position of the FM
antenna for the best reception.
Outdoor Antenna
For better FM stereo reception, connect an
outdoor FM antenna to the FM AERIAL (FM
ANTENNA) 75 Ω terminal using a 75 Ω
coaxial wire.
FM AERIAL 75Ω FM ANTENNA 75Ω
OR
C Speakers Connection
• Connect the right speaker to Front
terminal R, with the colored wire to +
and the black wire to -.
• Connect the left speaker to Front
terminal L, with the colored wire to +
and the black wire to -.
• Clip the stripped portion of the speaker
wire as shown.
pg 01-28/V39/21-En 7
E Subwoofer Out Connection
Connect the optional active subwoofer to
the SUBWOOFER OUT terminal. The
12 mm
subwoofer reproduces just the low bass
sound effect (e.g. explosions, the rumble of
unlock lock
spaceships, etc.). Be sure to follow the
instructions supplied with the subwoofer.
CAUTION:
– For optimal sound performance, it is
recommended to use the supplied F Connecting other
speakers.
– Do not connect more than one speaker
You can connect the audio left and right
to any one pair of + / - speaker
OUT terminals of a TV, VCR, Laser Disc
terminal.
player, DVD player or CD Recorder to the
– Do not connect speakers with
AUX IN terminals at the rear of the system.
impedance lower than the speakers
supplied. Please refer to
G Video Out Connection
SPECIFICATION section of this manual.
Connect the VIDEO OUT terminal at the
D Rear Surround Speakers rear of the system to the TV or VCR VIDEO
IN for viewing or recording.
Connection
Connect the optional Rear Surround
H Adjusting the Operating
Speakers to the REAR SURROUND
terminals. Be sure to follow the
instructions supplied with the Rear
Surround Speakers.
Before connecting the AC power cord to
the wall outlet, make sure that the voltage
selector at the rear of the system is set to
the local power line voltage. If not, reset
the selector before connecting to the wall
outlet.
I AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
equipment to your system
into the remote control as shown in the
battery compartment.
Voltage
• To avoid damage from possible battery
(for specific version only))
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.
6/8/01, 9:01 AM
PREPARATION
7
3139 116 19982