Philips FW-V39 Manual page 15

All manuals and user guides at all-guides.com
Programming Tracks
Programming tracks of a loaded disc is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 99 tracks can be
stored in the memory in any order (except
for MP3-CD) . When 99 tracks are stored
and you attempt to store another track, the
display will show "PROGRAM FULL".
Note:
– Program cannot be used for VCDs when
PBC is switched on. Switch off PBC
before storing tracks from such a VCD.
1 Load the desired discs in the disc trays.
2 Press the VCD (CD 1•2•3) button to
select the disc tray.
™ Programming can only be done on the
selected disc.
3 Press PROGRAM to start programming.
™ The PROG flag starts flashing.
™ It will cancel any previously
programmed tracks and selected
repeat mode.
4 Pressí or ë (or digit 0-9 on the
remote control) to select the desired
track.
- - + +
• For MP3-CD, press ALBUM - - /+ - + +
and TITLE - - /+ - - - + + + + to select the
desired Album and Title for
programming.
pg 01-28/V39/21-En 15
5 Press PROGRAM to store the track.
Playing the program
• Repeat steps 4 to 5 to store other
1 Press PLAYÉ Å to start program
tracks.
playback.
6 Press Ç once to end programming.
™ "PLAY PROGRAM" will be
™ The total number of tracks
programmed and total playing time
™ The track number and elapsed
appear on the display.
Notes:
– For MP3-CD, total playing time will not
• If you press REPEAT during program
be shown.
playback, all programmed tracks will be
– If the total playing time is more than
played repeatedly.
" 99:59 " then " --:-- " appears on the
™ "REPEAT TRACK", "REPEAT
display instead of the total playing time.
– During programming, if no button is
pressed within 20 seconds, the system
™ The REPEAT and PROG flags appear
will exit program mode automatically.
2 Press Ç to stop program playback.
Reviewing the program
Note:
Reviewing of program is possible only – If you press any other DISC DIRECT
PLAY buttons, the system will play the
when playback is stopped.
1 Press í or ë repeatedly to review
selected disc or track and the stored
the programmed tracks. program will be cleared.
2 Press Ç to exit review mode.
Erasing the program
playback is stopped)
• Press Ç.
™ "PROGRAM CLEARED" will be
Note:
– The program will be erased when the
system is disconnected from the power
supply. The system is switched to
standby mode when you change source
or when you change the program disc.
Repeat
You can play the current track or the
current disc repeatedly during playback.
1 Press REPEAT on the remote control to
displayed.
select the various repeat modes.
™ "REPEAT TRACK", "REPEAT
playing time of the current track will
DISC"or "REPEAT OFF" will be
appear on the display.
displayed.
™ The REPEAT flag appears on the
display.
• The current track or disc will now be
played repeatedly until you pressÇ.
PROGRAM" or "REPEAT OFF" will
2 Press REPEAT until the "REPEAT
be displayed.
OFF" mode is displayed to resume
normal playback.
on the display.
™ The REPEAT flag disappears from
the display.
(when
displayed.
6/8/01, 9:01 AM
CD / VCD / MP3-CD
(only on remote control)
15
3139 116 19982