Crown CT11020 Original Instructions Manual page 18

Symbol
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Wear protective gloves�
During operation, remove
the accumulated dust�
Milling direction�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
Meaning
English
18
Power tool designation
Power tool is designed for slot milling and treatment
of work piece brims made of wood based materials,
plastics, etc�
Power tool components
1 Milling depth gauge
2 Locking screw
3 Locknut
4 Stop lug
5 Base plate
6 Locking button for on / off switch
7 On / off switch
8 Ventilation slots
9 Spindle lock
10 Collet clamp nut
11 Scale
12 Router bit *
13 Wrench *
14 Nut M4 *
15 Dust extractor connecting adaptor *
16 Screw M4 (countersunk head) *
17 Parallel guide (assembly) *
18 Screw M4 (round head) *
19 Collet *
20 Spindle
21 Parallel guide nut *
22 Support *
23 Parallel guide adjusting screw *
24 Thrust plate *
25 Parallel guide locking screw *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Installing / replacing accessories (see fig. 1)
After prolonged operation, the router bit
can become very hot, remove it using
gloves. This will also reduce the risk of
injury by the cutting edge.
• Turn the power tool upside down�
• Press the spindle lock 9 and after making sure that
spindle 20 is locked, keep spindle lock 9 in a pressed
position (see fig. 1.1).
• Release nut 10 using the wrench 13 (see fig. 1.2).
• Install / replace the router bit, noting that the router
bit shank must be inserted into the collet 19 at least 20
mm deep (see fig. 1.3).