Task 6: Verify The Operation Of The Replacement Lcc - EMC2 EMC VNXe3100 Replacing

Task 6: Verify the operation of the replacement LCC

Copyright © 2011-2012 EMC Corporation. All rights reserved. Published in the USA.
Published August, 2012
EMC believes the information in this publication is accurate as of its publication date. The information is subject to change without
notice.
The information in this publication is provided as is. EMC Corporation makes no representations or warranties of any
kind with respect to the information in this publication, and specifically disclaims implied warranties of
merchantability or fitness for a particular purpose. Use, copying, and distribution of any EMC software described in this
publication requires an applicable software license.
2
EMC , EMC, and the EMC logo are registered trademarks or trademarks of EMC Corporation in the United States and other countries.
All other trademarks used herein are the property of their respective owners.
For the most up-to-date regulatory document for your product line, go to the technical documentation and advisories
section on EMC Online Support.
EMC VNXe3100/VNXe3150 — Replacing a Link Control Card (LCC) in a 12-Slot Disk-Array Enclosure (DAE)
Verify that the replacement LCC is recognized by your system, and operating correctly:
1. In Unisphere™, select System, then System Health.
2. Select the LCC in the Component list or the graphical view:
• In the Component list, the LCC should be marked with a status OK icon:
• In the graphical view, the LCC should be highlighted green.
If the system health monitor shows the LCC as faulted, contact your service provider.
Tasks to replace an LCC
5