Cisco Catalyst 9800-L Series Hardware Installation Manual page 45

Power Up and Initial Configuration
Configure virtual IP? [yes]:
Enter the virtual IP [192.0.6.1]:
Step 23
[Optional] Configure an RF network name.
Configure RF-Network Name? [yes]:
Enter the RF-Network Name: ciscorf
Step 24 [Optional] Configure high availability.
If you choose the deployment mode as Active or Standby, you will need to choose from one of the HA pairing
type:
a. RMI
b. RP-RP
Note
High Availability configuration
Please choose the HA pairing type
1. RMI
2. RP-RP
Enter your selection [1]:
If you choose RMI+RP, you need to select an interface to be used as redundancy port:
Enter the RMI IP for local chassis: 9.11.112.12
Enter the RMI IP for remote chassis: 9.11.112.13
Enter the gateway IP of the last resort: 9.11.112.1
Note
If you choose the deployment mode as Standby, you need to specify the VLAN ID for completing the pairing:
Enter the RMI IP for local chassis: 9.11.112.51
Enter the RMI IP for remote chassis: 9.11.112.50
Enter the wireless management VLAN: 112
If you choose RP, you need to select an interface to be used as redundancy port:
Select interface to be used as redundancy port
1. TwoGigabitEthernet0/0/2 [Up]
2. TwoGigabitEthernet0/0/3 [Up]
Choose the interface to config [1]: 2
Enter the local IP:
Enter the subnet mask:
Enter the remote IP:
For information on HA pairing types, see Part: High Availability (High Availability > Information
About Redundancy Management Interface) in Cisco Catalyst 9800 Series Wireless Controller
Software Configuration Guide, Cisco IOS XE Bengaluru 17.4.x.
If you have not configured a default route earlier, you need to enter the gateway IP of the last resort.
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
Day 0 CLI Wizard for the Controller
37